Invalid code for JFS 0000:0000 (ArcaOS 5.0.7)

[Igor]

ArcaOS 5.0.7
After passing the first phase of the installation and after the first reloading, the compiler freezes after the display of the message screen: Invalid code for JFS 0000:0000

Please help me.

[Eugene Tucker]

What is the hardware you are trying to install on CPU, Mainboard, and hard drive type and size etc.?

[Eugene Tucker]

Also what type of media are you using to install ARCA OS from
DVD of USB stick?

[Igor]

What is the hardware you are trying to install on CPU, Mainboard, and hard drive type and size etc.?

I use emachines eM350 series. Intel Atom N450, hard drive SATA WD1600BEVT in IDE mode. I use DANIS hd driver. AHCI driver do not working correctly (not show drive C) on this hardware.
I install ArcaOS from USB stick.

[Eugene Tucker]

Well I have had problems in the past with the USB install. It would not reconnect to the install after the first boot. On my last successful install this did not occur. But try the DVD install if yo can.

[Igor]

Solution. Before loading the system, remove from the connector the USB stick.
And quickly insert back after the start of the WPS. Requires dexterity.

[Mentore]

Solution. Before loading the system, remove from the connector the USB stick.
And quickly insert back after the start of the WPS. Requires dexterity.

Seems something timing related. Dunno if it is due to the WPS init phase versus driver timings, though...

Mentore

[Igor]

From my point of view, this is due to an error in the bootloader on the USB-stick. When removing the USB-stick, everything loads normally.
Perhaps switching to the BIOS boot order so that the loading from the hard disk is a priority.