Hi JGiacchi!
JGiacchi (20 Nov, 2003 17:37):
Check and see if you have the following lines in your config.sys i not sure exactly what each does but this is what i have and it works for me.BASEDEV=USBEHCD.SYS
BASEDEV=USBUHCD.SYS
BASEDEV=USBD.SYS
BASEDEV=USBHID.SYS
BASEDEV=USBMSD.ADD
Then check and see if the device is seen in the USB Resource Manager (found in the system setup folder) If its not then i can't help you.
The only other thing to try would be to click on the LVM refresh Removable media in the Drives folder.
Good luck!
Thankyou very much. You say it works for you. Do you have the same pen drive?
I'm not on my PC now, so I can't verify, but I'm pretty sure I don't have the BASEDEV=USBEHCD.SYS because my USB controller is an UHCI one. Anyway, I'll try to add it and see what happens.
Thankyou again..
Bye
Cris