| Subject | : | Network Printer through IPX/SPX |
| Author | : | andy agc@kyoceramita.com.ph |
| Date | : | 29 May, 2003 on 09:23 |
| Hi... COuld anyone suggest how to connect a kyocera mita FS-3800 through the network? Is there a way to point LPT1 to the network port? It only works in the command prompt but not in the Warp GUI. THanks!!! |
| Subject | : | Re:Network Printer through IPX/SPX |
| Author | : | Kim |
| Date | : | 04 Jun, 2003 on 21:46 |
| Just to make it clear, but has the printer any sort of networkcard or any interface that gives you the possibility to attach the printer to a LAN via LTP-port ? If this is the case that you're able to reach the printer via your LAN, check out following thread within the Networking section here in the forum. |
| Subject | : | Re:Network Printer through IPX/SPX |
| Author | : | Kim |
| Date | : | 05 Jun, 2003 on 01:08 |
| Sorry, reading the header a bit more.... sort of gives me an idea about that what I answered won't work out since this was based on TCP/IP. /Kim |
| Subject | : | Re:Network Printer through IPX/SPX |
| Author | : | andy agc@kyoceramita.com.ph |
| Date | : | 05 Jun, 2003 on 07:24 |
| HI Kim... yes the printer has an ethernet interface. I saw the posts on TCP/IP already but sad to say we really need it to work in IPX/SPX. THanks for replying anyways... =) |