Thank you very much for your Tips. But it’s not better, the same message is displayed :
“OS2 cannot access to the Hard Drive or to the floppy. The system will be stoppedâ€
I try to install OS/2 with a CD (with or without Partition Manager), but all the time the same message. With the option ‘D’ the following informations are displayed :IBM Corp. Bus Master DIE Driver for OS/2 Version 4.76
Controller 0 Port 01F0 IRQ: 000E Status: OK Bus Master DMA Scatter/Gather
PCI Rev: 2.10 Intel 82801 DB PCI ICH Rev:02 VID: 8086 DID: 24CB
Unit 0 Status: ATAPI Device Bus Master DMA Ultra DMA2/PI04
Controller 1 Port 0170 IRQ: 000F Status: OK Bus Master DMA Scatter/Gather
PCI Rev: 2.10 Intel 82801 DB PCI ICH Rev:02 VID: 8086 DID: 24CB
Unit 0 Status: OK SMS Enabled LBA Enabled Bus Master DMA Ultra DMA5/PI04 BPB model IC25N040ATCS05-0
Drive has valid Enhanced BIOS Extensions Version 48
OS2: log phys BIOS : log BPB : log
C 4864 82 688 1023 82 688
H 255 15 255 255 15
S 63 63 63 63 63
DIE: log phys Total Sectors
16 383 Avail 78 140 160
16 OS2 78 140 160
63 %Used 100,00
Perhaps do you have more idea now ?
I think it’s more a hard drive’s problem (40 Go).
Have a nice day !
Laurent