HarryWho (06 May, 2007 11:45):
The NIC is connected to a 8 port 1gigabit switch which indicates only a 100mbit connection.
The driver I am using is rtgnda12[.zip] and dated 12/2006 so there not too old. I also tried the GemMac stuff, but I could not get is to work at all.
I have the exact same setup and driver and that works fine, the driver should not matter anyhow, it is the connection between the card and the hub that is the problem, try switching cables, I have had some problems with older cables and gigabit ethernet, after all
Cat 5 was design for a different frequency range than is used in gbit ethernet
BTW what are the lights on the back of the card showing, 100Mb as well ?